Clear line Greenhouse Door Installation Guide

Step 1

The top door section needs to be inline with the upright door frame

Step 2

The door runners are bolted in the top of the door the bolt needs to be left quite loose its a bit hit and miss as this item will eventually adjust the height of your door.

Step 3

Now screw the top runner to the sides of the door then add the first plate in to its grooves. These plates will help to square the door.

Step 4

Add the cross section to the plate then slide in a polycarbonate panel then add the centre plate.

Step 5

Remember to add the plastic door runner to the bottom of the door frame.

Your finished door has two polycarbonate sections and three metal plates remove the protective coverings before fitting the door sections.

Do not tighten the bottom screws until the door is in place.

Step 6

Now the tricky bit the wheels on the door hang in the top runner on the door frame and the plastic channel then two plastic end caps are screwed in to the door runner.

The bottom channel needs to hand on the bottom of the door frame I adjusted the lower panel down then tightened the screws.

Step 7

The picture shows the greenhouse door from the out side.

Step 8

Now add the support bracket to the top of the door frame.

Step 9

Once its all done and in place you have almost completed your greenhouse by now you're am expert so check you have tightened all the nuts and bolts.